GuideRaised Garden Beds
Type the size of the planter box you want and get a measured drawing, cut list, shopping list, screws and soil for exactly that size.
The box is built like the measured planter box on this site: boards stacked edge to edge, long boards running the full length, short boards fitting between them, and a square post in each inside corner that reaches the top edge and stands a few centimetres below the bottom board as a leg. The calculator rounds the height to whole boards, adds a post in the middle of each long side for every extra 1.5 m (5 ft) so the boards do not bow, and packs the cut pieces onto the stock lengths you can buy, longest first, with 3 mm for each saw cut. It then picks the stock length that wastes least. Screws are two wherever a board crosses a post, plus 10% spare, about 2.3 times the board thickness long. Soil is the inside area times the board height, less 3 cm at the top. Tick the cap board to add boards laid flat around the top edge: the long caps run the full length plus the overhang at both ends, the short caps fit between them, and they are screwed down into the post tops.
Worked example: the original planter box is 124.4 × 54.4 cm and 52.5 cm high, with 2.2 × 9.5 cm boards, 4.8 × 4.8 cm posts and 5 cm legs. That is 5 rows of boards (47.5 cm) on 5 cm legs: 10 long boards of 124.4 cm, 10 short boards of 50.0 cm (54.4 − 2 × 2.2) and 4 posts of 52.5 cm. Inside it is 120 × 50 cm, so filled 3 cm below the rim it takes about 267 litres of soil.
The results are estimates for planning and shopping. Check your measurements, and buy a little extra rather than too little.
Member projectRaised Garden Beds
Member projectRaised Garden Beds
Our designRaised Garden Beds
Open designRaised Garden Beds
From diyoutdoorbuilds.com/tools/planter-box-plans-calculator · DIY Outdoor Builds